Knew Concepts - Fine Metalsmithing Equipment Designed for Artisans

Knew Concepts Spare Parts

View larger image.

Replacement Swivel Blade Clamps for Newer Saws
(post-2010)

Item #125.850

This replacement set of swivel blade clamps is for newer (post 2010) fret/jeweler’s saws. They will not fit older (pre-2010) saws, or
coping saws.

See this image for reference.

Price: $27.00

Replacement Instructions

Use a 5/64" allen wrench to loosen the set screws in the clamp at the handle end of the saw and remove clamp. Replace with the new clamp, re-tighten the set screws. Note the location of the brass knob on the screw for front/upper old clamp. Unscrew the brass knob from the old upper/front clamp, and remove it. Unscrew brass knob from new clamp, thread it back through the hole in the axle (if you have a lever saw) and replace the brass knob on the end of the screw. Adjust until you can tension a blade properly. Start by putting the new knob in roughly the same position as the old one. Stop if you see any screw sticking out of the back of the brass knob. That’s too tight.

View larger image.

Replacement Solid Blade Clamps for Newer Saws
(post-2010)

Item #125.840

This replacement set of solid blade clamps is for newer (post 2010) fret/jeweler’s saws. They will not fit older (pre-2010) saws,
or coping saws.

See this image for reference.

Price: $22.00

Replacement Instructions

Use a 5/64" allen wrench to loosen the set screws in the clamp at the handle end of the saw and remove clamp. Replace with the new clamp, re-tighten the set screws. Note the location of the brass knob on the screw for front/upper old clamp. Unscrew the brass knob from the old upper/front clamp, and remove it. Unscrew brass knob from new clamp, thread it back through the hole in the axle (if you have a lever saw) and replace the brass knob on the end of the screw. Adjust until you can tension a blade properly. Start by putting the new knob in roughly the same position as the old one. Stop if you see any screw sticking out of the back of the brass knob. That’s too tight.

View larger image.

Replacement Delrin Ring Hook

Item #325.110

Replacement delrin hook for cutting rings. Just unscrew the old one from your Bench Pin and replace it with this new one. Replacement screws are not included.

Price: $8.00

Knew Concepts Blade Clamp Knobs

Blade Clamp Knobs

Standard issue on all current production saws. Machined from solid billet aluminum, and knurled for positive grip. Easily replace the original black plastic Tee knobs. The screw is Grade 8 steel for an extremely long life of usage.

Price: $8.50

Brass Tension Knob

Brass Tension Knob

Item #125.860

Replacement solid brass knurled knob will fit the tension screws on any of our saws, new, old, coping, it fits them all.

Price: $5.00

Black Plastic Knob

Black Plastic Knob

Item #125.865

Replacement black plastic knobs will fit either the ring hook on the stainless steel bench pin, (you need two) or as a replacement for the original issue black plastic tension knobs on our older fret saws.

Price: $3.00


Facebook Pinterest Instagram Twitter